Click image to view full size image
200bar 1/2 stainless steel air or water high pressure solenoid valve
1. Specification
1. For special very high pressure applications.
2. SUS316 material with good Acid and alkali resistant.
| Model | HP250 HP350 |
| Working Medium | Clean Air /Water |
| Working type | Direct action 2/2 |
| Pattern | Normally close |
| Orifice | 1mm |
| Insulation class | F class |
| Joint Pipe Bore | G1/8"-G1/2" |
| Pretection class | IP65 |
| Working-pressure | 0~25MPa 0~35MPa |
| Rated voltage | AC/DC24V-220V -10%~+10% |
| Power | AC22VA/DC14W |
| Max.pressure | 45MPa |
| Material of Body | Stainless steel SUS316 |
| Seal Material | PTFE |
2.Dimensions
Maintenance instructions:
1. attention to check the use of components, in the transport process is damaged, and then install the use of.
2. When installing, please note that the gas flow direction and the takeover are correct.
3. when using, please strictly comply with the technical requirements, such as the operating voltage, operating frequency, working pressure, the use of temperature, the whole machine debugging, it is recommended to use a manual device debugging, and then through power debugging.
4. Please pay attention to dust, it is recommended to install the exhaust port or muffler muffler throttle.
5. When connecting pipe, pay attention to only release the strap around the joint may not exceed the end face of the tooth, and pay attention to the elimination of pipe fittings, metal particles inside the pipe, dust and oil, etc
200 Bar High Pressure Solenoid Valve , Stainless Steel Solenoid Valves Air / Water
